cli mode¶
The following operations can be performed on "cli mode":
set cli mode¶
Use this command to specify how the CLI should display command output.
Synopsys¶
set cli mode [-page ( ON | OFF )] [-total ( ON | OFF )] [-color ( ON | OFF )] [-disabledFeatureAction <disabledFeatureAction>] [-timeout <secs>] [-regex ( ON | OFF )]
Arguments¶
page
Determines whether output that spans more than one screen is "paged". Specify ON to pause the display after each screen of ouput.
Possible values: ON, OFF
Default value: OFF
total
Determines whether CLI "show" commands display a total count of objects before displaying the objects themselves.
Possible values: ON, OFF
Default value: OFF
color
Specifies whether output can be shown in color, if the terminal supports it.
Possible values: ON, OFF
Default value: OFF
disabledFeatureAction
Specifies what will happen when a configuration command is issued for a disabled feature. The following values are allowed:
NONE - The action is allowed, and no warning message is issued.;
ALLOW - The action is allowed, but a warning message is issued.;
DENY - The action is not allowed.
Possible values: NONE, ALLOW, DENY
Default value: NS_ALLOW
timeout
CLI session inactivity timeout, in seconds. If Restrictedtimeout argument of system parameter is enabled, Timeout can have values in the range [300-86400] seconds and also climode timeout cannot be configured beyond admin configured value. If Restrictedtimeout argument of system parameter is disabled, Timeout can have values in the range [0, 10-100000000] seconds. Default value is 900 seconds.
Default value: -1
regex
If ON, regular expressions can be used as argument values
Possible values: ON, OFF
Default value: ON
unset cli mode¶
Use this command to remove cli mode settings.Refer to the set cli mode command for meanings of the arguments.
Synopsys¶
unset cli mode [-page] [-total] [-color] [-disabledFeatureAction] [-timeout] [-regex]
show cli mode¶
Use this command to display the current settings of parameters that can be set with the 'set cli mode' command.
Synopsys¶
show cli mode
Outputs¶
page
Determines whether output that spans more than one screen is "paged". Specify ON to pause the display after each screen of ouput.
total
Determines whether CLI "show" commands display a total count of objects before displaying the objects themselves.
color
Specifies whether output can be shown in color, if the terminal supports it.
disabledFeatureAction
Specifies what will happen when a configuration command is issued for a disabled feature. The following values are allowed:
NONE - The action is allowed, and no warning message is issued.;
ALLOW - The action is allowed, but a warning message is issued.;
DENY - The action is not allowed.
argMark
mark
noLicenseAction
no licence
diagLevel
diagnostic level
timeout
CLI session inactivity timeout, in seconds. If Restrictedtimeout argument of system parameter is enabled, Timeout can have values in the range [300-86400] seconds and also climode timeout cannot be configured beyond admin configured value. If Restrictedtimeout argument of system parameter is disabled, Timeout can have values in the range [0, 10-100000000] seconds. Default value is 900 seconds.
timeoutKind
From where the timeout has been inherited.
regex
If ON, regular expressions can be used as argument values
r
regular expression
format
format
stats
serverPort