vrIDParam¶
The following operations can be performed on "vrIDParam":
set vrIDParam¶
Sets global parameters of VMACs on the NetScaler appliance.
Synopsys¶
set vrIDParam [-sendToMaster ( ENABLED | DISABLED )] [-helloInterval <msecs>] [-deadInterval <secs>]
Arguments¶
sendToMaster
Forward packets to the master node, in an active-active mode configuration, if the virtual server is in the backup state and sharing is disabled.
Possible values: ENABLED, DISABLED
Default value: DISABLED
helloInterval
Interval, in milliseconds, between vrrp advertisement messages sent to the peer node in active-active mode.
Default value: 1000
Minimum value: 200
Maximum value: 1000
deadInterval
Number of seconds after which a peer node in active-active mode is marked down if vrrp advertisements are not received from the peer node.
Default value: 3
Minimum value: 1
Maximum value: 3
Example¶
set vrIDParam -sendToMaster ENABLED
unset vrIDParam¶
Use this command to remove vrIDParam settings.Refer to the set vrIDParam command for meanings of the arguments.
Synopsys¶
unset vrIDParam [-sendToMaster] [-helloInterval] [-deadInterval]
show vrIDParam¶
Displays the VRID global settings on the NetScaler appliance.
Synopsys¶
show vrIDParam
Outputs¶
sendToMaster
Forward packets to the master node, in an active-active mode configuration, if the virtual server is in the backup state and sharing is disabled.
helloInterval
Interval, in milliseconds, between vrrp advertisement messages sent to the peer node in active-active mode.
deadInterval
Number of seconds after which a peer node in active-active mode is marked down if vrrp advertisements are not received from the peer node.